Question: What does E1 mean on washing machine?

When the Washing Machine is displaying E1 in the panel, it is indicating an error in the water supply. The appliance is not detecting that the unit is filling with water. To resolve, checking the following: • Check whether the water supply is turned on and that there is adequate water pressure.

How do I fix error code 1E?

Samsung washing machine IE error – Possible solutionsDo a hard power reset. You need to unplug your Samsung washing machine for about 5 minutes as this will normally reset most of the electronic glitches or any other issues with software that may be present. Ensure proper wire connection. Replace the pressure switch.Apr 21, 2020

What does F3 E1 mean on a Whirlpool washer?

F3 E1 error code Whirlpool washer appears on the screen when the control board cannot detect the water level to continue the program. Having appeared once, this signal constantly appears after the washing machine is turned on and sometimes blocks it during operation.

How do you fix IE error on LG top load washer?

An IE error code indicates that the washer was unable to fill with water....Turn off the homes hot and cold water supply taps/valve.Remove the water inlet hoses from the washer. Check the inlet filters on the inlet valves of the washer, inspect for any mineral deposits or other debris that may be clogging them. •18 Nov 2020

Why is my LG dishwasher flashing?

Common solutions for: LG Dishwasher lights flashing or blinking. The heating element heats up the water to operating temperature. If the water doesnt reach the proper temperature after a set amount of time, a light on the control panel might start flashing. If the heating element does not have continuity, replace it.

What does E1 and F9 mean on a Whirlpool washer?

F9 E1 Code in the display: This error code indicates that drain times are longer than expected, typically over eight (8) minutes.

What does F8 E1 mean on a Whirlpool washer?

too long to fill If F8 E1 or LF (too long to fill) appears in display, it means the washer is taking too long to fill. Its possible the drain hose extends more than 4.5 (114 mm) into standpipe. Either the F8E1 or the LF error codes may indicate there is some problem with the water supply going to the washer.

Tell us about you

Find us at the office

Smack- Kinneer street no. 65, 62402 Kingston, Jamaica

Give us a ring

Drexel Lepak
+30 694 593 49
Mon - Fri, 7:00-15:00

Contact us